LPC4088 32-bit ARM Cortex-M4 Microcontroller Development Kit

The LPC4088 OEM Board from Embedded Artists is equipped with NXP"s Cortex-M4 based LPC4088 microcontroller suitable for a wide range of applications that requires advanced communication and high quality graphic displays. The kit comprises a plug in module (the “OEM board”) with the LPC4088 microcontroller and memory, and a base board which provides access to the microcontroller’s rich set of peripherals. This kit is ideal for engineers who want to full explore and prototype with the LPC4088.

LPC4088 OEM Board:

• Processor NXP"s Cortex-M4 LPC4088 microcontroller in a BGA package
• Program Flash 128 MB NAND FLASH + 512 kB internal
• Data Memory 32 MB SDRAM + 96 KB internal SRAM + 4 KB internal E²PROM
• 32-bit data bus to SDRAM (16-bit on special order)
• SPIFI Memory 32 Mbit QSPI flash
• Ethernet 100/10M Ethernet interface based on SMSC LAN8720 Ethernet PHY
• 12 MHz crystal for CPU and 32.768 kHz crystal for RTC
• 200 position expansion connector (as defined in SODIMM standard), 0.6 mm pitch
• Buffered 32-bit databus

OEM Base Board:

200 position, 0.6 mm pitch SODIMM connector for OEM Board

LCD expansion connector with control signals for touch screen interface

Expansion connector with all OEM Board signals

Ethernet connector (RJ45)

CAN interface and connector (provision for second CAN interface)

MMC/SD interface and connector

USB1: OTG or Host interface and connector

USB2: Device or Host interface and connector

Provision for NXP JN5148 RF module (former Jennic) interface (RF module not included)

RS422/485 interface and connector

I²S audio codec (mic in, line in, line out, headphone out)

SWD/JTAG connector, trace connector and pads for ETM connector

Serial Expansion Connector, 14-pos connector with UART/I²C/SPI/GPIO pins

Optional coin cell battery for RTC and LED on ALARM output (coin cell not included)

Parallel NOR flash on external memory bus

16-bit register and LEDs on external memory bus

5-key joystick, 5 push-buttons

3-axis accelerometer (I²C connected)

LM75 temperature sensor (I²C connected)

9 LEDs (8 via I²C and one on ISP-ENABLE)

Trimming potentiometer to analog input

USB-to-serial bridge on UART #0 (FT232R) and ISP functionality

Reset push-button and LED

Speaker output on analog output from OEM Board, or from I²S audio codec