USB-UART LP Bridge Controller 28-Pin SSOP

CY7C65213 is a fully integrated USB-to-UART bridge that provides a simple method to upgrade UART-based devices to USB with a minimal number of components. CY7C65213 includes a USB 2.0 Full-Speed controller, a UART transceiver, an internal regulator, an internal oscillator, and a 512-byte flash in a 32-pin QFN and 28-pin SSOP package.

• USB 2.0-certified, Full-Speed (12 Mbps)
• Supports communication driver class (CDC), personal health care device class (PHDC), and vendor-specific drivers
• Battery charger detection (BCD) compliant with USB Battery Charging Specification, Rev. 1.2 (Peripheral Detect only)
• Integrated USB termination resistors
• Single-channel configurable UART interface
• Data rates up to 3 Mbps
• 256 bytes for each transmit and receive buffer
• Data format:
• 7 to 8 data bits
• 1 to 2 stop bits
• No parity, even, odd, mark, or space parity
• Supports parity, overrun, and framing errors
• Supports flow control using CTS, RTS, DTR, DSR
• Single-channel configurable SPI interface
• Master/slave up to 3 MHz
• Data width: 4 bits to 16 bits
• 256 bytes for each transmit and receive buffer
• Supports Motorola, TI, and National SPI modes
• Single-channel configurable I2C interface
• Master/slave up to 400 kHz
• 256 bytes each transmit and receive buffer
• Supports multi-master I2C
• CapSense®
• SmartSense™ Auto-Tuning is supported through a Cypress-supplied configuration utility
• Max CapSense buttons: 5
• GPIOs linked to CapSense buttons
• General-purpose input/output (GPIO) pins: 10
• 512-byte flash for storing configuration parameters
• Configuration utility (Windows) to configure the following:
• Vendor ID (VID), Product ID (PID), and Product and Manufacturer descriptors
• UART/I2C/SPI