Temp Sensor Digital Serial (2-Wire) 6-Pin UDFN T/R

The STTS751 is a digital temperature sensor which communicates over a 2-wire SMBus 2.0 compatible bus. The temperature is measured with a user-configurable resolution between 9 and 12 bits. At 9 bits, the smallest step size is 0.5 °C, and at 12 bits, it is 0.0625 °C. At the default resolution (10 bits, 0.25 °C/LSB), the conversion time is nominally 21 milliseconds.The open-drain EVENToutput is used to indicate an alarm condition in which the measured temperature has exceeded the user-programmed high limit or fallen below the low limit. When the EVENTpin is asserted, the host can respond using the SMBus Alert Response Address (ARA) protocol to which the STTS751 will respond by sending its slave address.The STTS751 is a 6-pin device that supports user-configurable slave addresses. Via the pull-up resistor on the Addr/Thermpin, one of four different slave addresses can be specified. Two order numbers (STTS751-0 and STTS751-1) provide two different sets of slave addresses bringing the total available to eight. Thus, up to eight devices can share the same 2-wire SMBus without ambiguity, thereby allowing monitoring of multiple temperature zones in an application.The two-wire interface can support transfer rates up to 400 kHz. Two small footprint packages are available: a UDFN-6L and a standard SOT23-6L package.

Operating voltage 2.25 V to 3.6 V

Operating temperature –40 °C to +125 °C

Programmable

10 different conversion rates 0.0625 to 32 conversions/sec. 1 conversion/sec. - default

4 different resolutions 9-bit (0.5 °C/LSB) to 12-bit (0.0625 °C/LSB) 10-bit (0.25 °C/LSB) - default

Low supply current

50 µA (typ) for 8 conversions/sec.

20 µA (typ) for 1 conversion/sec.

3 µA (typ) standby

Accuracy

±1.0 °C (typ) 0 °C to +85 °C

±2.0 °C (typ) –40 °C to +125 °C

One-shot mode for power saving

Fast conversion time 21 ms (typ) 10-bit

Pull-up resistor value allows single pin to select one of four slave addresses

Supports 400 kHz serial clock

SMBus 2.0 compatible

SMBus ALERT (ARA) support

SMBus timeout

RoHS/green