Quad Output Controller 48-Pin TQFN EP T/R

The MAX17019 is a high-input-voltage quad-output controller (up to 38V). The MAX17019 provides a compact, low-cost controller capable of providing four independent regulators—a main stage, a 3AP-P internal step-down, a 5AP-P internal step-down, and a 2A source/sink linear regulator. The input voltage is up to 38V. The internal switching regulators include 5V synchronous MOSFETs that can be powered directly from a single Li+ cell or from the main 3.3V/5V power stages. Finally, the linear regulator is capable of sourcing and sinking 2A to support DDR termination requirements or to generate a fixed output voltage. The step-down converters use a peak current-mode, fixed-frequency control scheme—an easy to implement architecture that does not sacrifice fast-transient response. This architecture also supports peak current-limit protection and pulse-skipping operation to maintain high efficiency under light-load conditions. Separate enable inputs and independent open-drain power-good outputs allow flexible power sequencing. A soft-start function gradually ramps up the output voltage to reduce the inrush current. Disabled regulators enter high-impedance states to avoid negative output voltage created by rapidly discharging the output through the low-side MOSFET. The MAX17019 also includes output undervoltage, output overvoltage, and thermal-fault protection. The MAX17019 is available in a 48-pin, 6mm x 6mm thin QFN package.

• Fixed-Frequency, Current-Mode Controllers
• 5.5V to 38V Input Range (Step-Down)
• 1x Step-Down Controller
• 1x Internal 5A_P-P Step-Down Regulator
• 1x Internal 3A_P-P Step-Down Regulator
• 1x 2A Source/Sink Linear Regulator with Dynamic REFIN
• Internal BST Diodes
• Internal 5V 50mA Linear Regulator
• Fault Protection-Undervoltage, Overvoltage, Thermal, Peak Current Limit
• Independent Enable Inputs and Power-Good Outputs
• Voltage-Controlled Soft-Start
• High-Impedance Shutdown
• 10µA (typ) Shutdown Current