Processor Supervisor 4.575V 4.575V 16-Pin PDIP N

The MAX807 microprocessor (µP) supervisory circuit reduces the complexity and number of components needed to monitor power-supply and battery-control functions in µP systems. A 70µA supply current makes the MAX807 ideal for use in portable equipment, while a 2ns chip-enable propagation delay and 250mA output current capability (20mA in battery-backup mode) make it suitable for larger, higher-performance equipment. The MAX807 comes in 16-pin DIP, SO, and TSSOP packages, and provides the following functions: µP reset. The active-low RESET output is asserted during power-up, power-down, and brownout conditions, and is guaranteed to be in the correct state for VCC down to 1V. Active-high RESET output. Manual-reset input. Two-stage power-fail warning. A separate low-line comparator compares VCC to a threshold 52mV above the reset threshold. This low-line comparator is more accurate than those in previous µP supervisors. Backup-battery switchover for CMOS RAM, real-time clocks, µPs, or other low-power logic. Write protection of CMOS RAM or EEPROM. 2.275V threshold detector provides for power-fail warning and low-battery detection, or monitors a power supply other than +5V. BATT OK status flag indicates that the backup-battery voltage is above +2.275V. Watchdog-fault outputasserted if the watchdog input has not been toggled within a preset timeout period.

• Precision 4.675V (MAX807L), 4.425V (MAX807M), or 4.575V (MAX807N) Voltage Monitoring
• 200ms Power-OK/Reset Time Delay
• RESET-bar and RESET Outputs
• Independent Watchdog Timer
• 1µA Standby Current
• Power Switching
  • 250mA in V_CC Mode
  • 20mA in Battery-Backup Mode

On-Board Gating of Chip-Enable Signals;

• 2ns CE Gate Propagation Delay

MaxCap® and SuperCap Compatible

Voltage Monitor for Power Fail

Backup-Battery Monitor

Guaranteed active-low RESET Valid to V_CC = 1V

±1.5% Low-Line Threshold Accuracy 52mV above Reset Threshold