LED DRVR 9Segment 25-Pin uSMD T/R

The LP5523 is a 9-channel LED driver designed to produce lighting effects for mobile devices. A high-efficiency charge pump enables LED driving over full Li-Ion battery voltage range. The device is equipped with an internal program memory, which allows operation without processor control. The LP5523 maintains excellent efficiency over a wide operating range by autonomously selecting the best charge pump gain based on LED forward voltage requirements. LP5523 is able to automatically enter power-save mode when LED outputs are not active, thus lowering idle current consumption down to 10 µA (typ).The LP5523 has an I2C-compatible control interface with four pin selectable addresses. The device has a flexible General Purpose Output (GPO), which can be used as a digital control pin for other devices. INT pin can be used to notify processor when a lighting sequence has ended (interrupt -function). Also, the device has a trigger input interface, which allows synchronization, for example, between multiple LP5523 devices.The device requires only four small and low-cost ceramic capacitors. The LP5523 is available in a tiny 25-bump 2.27 mm x 2.27 mm x 0.60 mm DSBGA package (0.4 mm pitch). 

Three Independent Program Execution Engines, 9 Programmable Outputs with 25.5 mA Full-Scale Current, 8-Bit Current Setting Resolution and 12-Bit PWM Control Resolution

Adaptive High-Efficiency 1x/1.5x Fractional Charge Pump - Efficiency Up to 94%

LED Drive Efficiency Up to 93%

Charge Pump with Soft Start and Over-Current/Short-Circuit Protection

Built-in LED Test

200 nA Typical Standby Current

Automatic Power Save Mode; I_VDD = 10 µA (typ.)

Two-Wire I²C-Compatible Control Interface

Flexible Instruction Set

Large SRAM Program Memory

Small Application Circuit

Source (High-Side) Drivers

Architecture Supports Color Control