JTAG-SMT2-NC Surface Mount Programming Module for Xilinx FPGAs

The JTAG-SMT2-NC has all of the same features as theJTAG-SMT2, but without a USB connector pre-mounted on the board.

• All the same features as the JTAG-SMT2, but built without the USB connector.
• Small, complete all-in-one JTAG programming/debugging solution for Xilinx FPGAs
• Compatible with all Xilinx tools.
• Compatible with IEEE 1149.7-2009 Class T0 – Class T4 (includes 2-Wire JTAG).
• GPIO pin allows debugging software to reset the processor core of Xilinx’s Zynq™ platform.
• Single 3.3V supply.
• A separate Vref drives JTAG signal voltages; Vref can be any voltage between 1.8V and 5V.
• High-speed USB2 signals are pinned out for user design that can drive JTAG/SPI bus at up to 30Mbit/sec (frequency settable by user).
• SPI programming solution (modes 0 and 2 up to 30Mbit/sec, modes 1 and 3 up to 2Mbit/sec).
• Small form-factor surface-mount module can be directly loaded on target boards.
• A similar circuit is available as a stand-alone programming cable, theJTAG-HS2.