Hot-Insertion Protection 24-Pin QSOP T/R

The MAX7314 I²C-compatible serial interfaced peripheral provides microprocessors with 16 I/O ports plus one output-only port and one input-only port. Each I/O port can be individually configured as either an open-drain current-sinking output rated at 50mA and 5.5V, or a logic input with transition detection. The output-only port can be assigned as an interrupt output for transition detection. The outputs are capable of driving LEDs, or providing logic outputs with external resistive pullup up to 5.5V. Eight-bit PWM current control is built in for all 17 output ports. A 4-bit global control applies to all LED outputs and provides coarse adjustment of current from fully off to fully on with 14 intensity steps in between. Each output has an individual 4-bit control, which further divides the globally set current into 16 more steps. Alternatively, the current control can be configured as a single 8-bit control that sets all outputs at once. Each output has independent blink timing with two blink phases. All LEDs can be individually set to be on or off during either blink phase, or to ignore the blink control. The blink period is controlled by a clock input (up to 1kHz) on BLINK or by a register. The BLINK input can also be used as a logic control to turn the LEDs on and off, or as a general-purpose input. The MAX7314 supports hot insertion. All port pins, the active-low INT output, SDA, SCL, active-low RST, BLINK, and the slave address input ADO remain high impedance in powerdown (V+ = 0V) with up to 6V asserted upon them. The MAX7314 is controlled through a 2-wire serial interface, and uses four-level logic to allow four I²C addresses from only one select pin.

• 400kbps, 2-Wire Serial Interface, 5.5V Tolerant
• 2V to 3.6V Operation
• Overall 8-Bit PWM LED Intensity Control
  • Global 16-Step Intensity Control
  • Individual 16-Step Intensity Controls

2-Phase LED Blinking

50mA Maximum Port Output Current

Supports Hot Insertion

Outputs are 5.5V-Rated Open Drain

Inputs are Overvoltage Protected to 5.5V

Transition Detection with Interrupt Output

1.2µA (typ), 3.6µA (max) Operating Current

Small 4mm x 4mm, Thin QFN Package

-40°C to +125°C Temperature Range