DRAM Module DDR3 SDRAM 2Gbyte 244ULP Mini-UDIMM

DDR3 SDRAM modules are high-speed, CMOS dynamic random access memory modules that use internally configured 8-bank DDR3 SDRAM devices. DDR3 SDRAM modules use DDR architecture to achieve high-speed operation. DDR3 architecture is essentially an 8n-prefetch architecture with an interface designed to transfer two data words per clock cycle at the I/O pins. A single read or write access for the DDR3 SDRAM module effectively consists of a single 8n-bit-wide, one-clock-cycle data transfer at the internal DRAM core and eight corresponding n-bit-wide, one-half-clock-cycle data transfers at the I/O pins. DDR3 modules use two sets of differential signals: DQS, DQS# to capture data and CK and CK# to capture commands, addresses, and control signals. Differential clocks and data strobes ensure exceptional noise immunity for these signals and provide precise crossing points to capture input signals. Fly-By Topology. DDR3 modules use faster clock speeds than earlier DDR technologies, making signal quality more important than ever. For improved signal quality, the clock, control, command, and address buses have been routed in a fly-by topology, where each clock, control, command, and address pin on each DRAM is connected to a single trace and terminated (rather than a tree structure, where the termination is off the module near the connector). Inherent to fly-by topology, the timing skew between the clock and DQS signals can be easily accounted for by using the write-leveling feature of DDR3.

• DDR3 functionality and operations supported as defined in the component data sheet
• 244-pin, ultra-low profile, 17.9mm, mini-unbuffered dual in-line memory module (ULP Mini-UDIMM)
• Fast data transfer rates: PC3-12800, PC3-10600, PC3-8500, or PC3-6400
• 2GB (256 Meg x 72)
• VDD = 1.5V ±0.075V
• VDDSPD = 3.0–3.6V
• Supports ECC error detection and correction
• Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
• Single-rank
• On-board I2C temperature sensor with integrated serial presence-detect (SPD) EEPROM
• 8 internal device banks
• Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Gold edge contacts
• Halogen-free
• Fly-by topology
• Terminated control, command, and address bus