Digital Termination Array 38-Pin HTSSOP Tube

CLT01-38S4 adds to the existing current limiter family. Still focusing on power consumption savings, the whole series allows each customer to find the right solution.The CLT01-38S4 is an octal input termination device with a high speed SPI output. Its maximum input data rate is 400 kbps while the output SPI speed is 6.25 MHz.As in previous versions, robustness is a key feature of CLT01-38S4. The product is compliant with surge standards defined in IEC 61000-4-x.It can run all types of sensor according to IEC 61131-2. Type 1 and 3 with a 2.35 mA limited current and type 2 using two inputs per sensor with the correct RREF.

8-input circuit in common ground low side topology

Wide range input DC voltage V_I: -30 V to 35 V

On state threshold: < 11="" v="" with="">_I= 2.2 kO

Off state threshold: I_in> 1.5 mA or V_i> 5 V

Protected against -30 V reverse polarity

Typical I_LIM= 2.1 to 2.6 mA adjustable current limiters

Tight current tolerance including temperature compensation: ±10%

Serial output with an SPI communication bus

Clock frequency up to 6.25 MHz

CPHA = CPOL = 0 bus master operation

Multi CLT operation in daisy chain connection

16-bit mode: 8 bits for data / 8 bits for control

Minimum capture time: 4 µs

Input data rate: 200 kbps/100 kHz

Minimum propagation transfer time: 7 µs

8-bit mode: 8 bits for data

Minimum capture time: 2.5 µs

Input data rate: 400 kbps/200 kHz

Minimum propagation transfer time: 4 µs

VCC = -0.3 to +35 V with RC = 2.2 kO

Ambient temperature range: -25 to +85°C

Digital inputs for programmable logic controller and decentralized I/O modules

Benefits

Enables input to meet type 1, 2 and 3 characteristics of IEC 61131-2 standard

Compatible operation with 2 wires proximity sensor according EN 60947-5-2 standard

Compact board with surface mount integration and reduced count of isolated couplers

Reduces the count of input-output of the bus controller circuit

Provides energy-less input LED visual status

Enhanced functional reliability

Built-in over voltage robustness and immune data transfer

Reduced dissipation: 78 mW max. per channel

Complies with following standards (R_I= 2.2 O, R_C= 2.2 O, C = 33 nF):

Electrostatic discharge, IEC 61000-4-2:±8 kV contact discharge±15 kV air discharge

Electrical transient immunity IEC 61000-4-41:F_SCK= 6.25 MHz, ±3 kVF_SCK= 10 kHz, ±4 kV

Voltage surge IEC 61000-4-5Input: ±15 kVPower supply: ±2.5 kV