Camera Interface Bridge 72-Pin BGA

The MIPI CSI-2 to Parallel port and Parallel port to CSI-2 (TC358746AXBG/TC358748XBG) is a bridge device that converts MIPI data transfers from devices such as a camera to an application processor over a Parallel port interface. All internal registers can be access through I2C or SPI (in CSI out case only).

• CSI-2 TX/RX Interface
  • MIPI CSI-2 compliant (Version 1.01 Revision 0.04 – 2 April 2009)
  • Configurable to TX or RX controller
  • Supports up to 1Gbps per data lane
  • Supports up to 4 data lanes
  • Supports video data formats
    • RX: RAW8/10/12/14, YUV422 (CCIR/ITU 8/10- bit), RGB888/666/565 and User-Defined 8-bit
    • TX: YUV422 (CCIR/ITU 8/10-bit), YUV444, RGB888/666/565 and RAW8/10/12/14
• Parallel Port Interface
  • Supports data formats
  • 24-bit bus – un-packed format (Both Input and Output mode)
    • RGB888/666/565, RAW8/10/12/14 and YUV422 8-bit (on 8/16-bit data bus) and 10-bit data formats
    • YUV444 (Parallel Input mode only)
  • YUV422 8-bit – ITU BT.656 and ITU BT.601 (Parallel input mode only)
    • Up to 100 MHz PCLK frequency for Output mode, and 166 MHz for Input mode
• I2C Slave Interface (CS = L)
  • Support for normal (100 kHz), fast mode (400 kHz) and special mode (1 MHz)
  • Configure all TC358746AXBG/TC358748XBG internal registers
• SPI Slave Interface (Only applicable in CSIOut configuration, MSEL = H, and CS = H)
  • SPI interface support for up to 25 MHz operation
  • Configure all TC358746AXBG/TC358748XBG internal registers
• GPIO signals
  • 3 GPIO signals
    • Three GPIO signals can be configured as control signals (MCLK, CXRST, XShutdown) for CSI-2 RX device
    • Or one GPIO signal can be configured as INT signal for Parallel interface
• System
  • Clock and power management support to achieve low power states
• Power supply inputs
  • Core and MIPI D-PHY: 1.2 V
  • I/O: 1.8 V – 3.3 V