Active Filter Dual Continuous Time Low Pass 5th Order 7.6MHz 8-Pin SOIC N T/R

The FMS6406 is a dual Y/C 5th-order Butterworth low pass video filter optimized for minimum overshoot and flat group delay. The device also contains a summing circuit to generate filtered composite video, an audio trap and group delay compensation circuit. The audio trap removes video information in the spectral location of the subsequent RF audio carrier. The group delay circuit predictors the signal to compensate for the inherent receiver IF filter’s group delay distortion. In a typical application, the Y and C input signals from DACs are AC-coupled into the filters. Both channels have DC-restore circuitry to clamp the DC-input levels during video sync. The Y and C channels use separate feedback clamps. The clamp pulse is derived from the Y channel. All outputs are capable of driving 2Vpp, AC or DC-coupled, into either a single or dual video load. A single video load consists of a series 75W impedance matching resistor connected to a terminated 75W line, this presents a total of 150W of loading to the part. A dual load would be two of these in parallel which would present a total of 75W to the part. The gain of the Y, C and CV signals is 6dB with 1Vpp input levels. All video channels are clamped during sync to establish the appropriate output voltage reference levels.

• 7.6MHz 5th-Order Composite Video Filter
• 14dB Notch at 4.425MHz to 4.6MHz for Sound Trap Capable of Handling Stereo
• 50dB Stopband Attenuation at 27MHz on CV Output
• >0.5dB Flatness to 4.2MHz on CV Output
• Equalizer and Notch Filter for Driving RF Modulator with Group Delay of -180ns
• No External Frequency Selection Components or Clocks
• <5ns Group Delay on CV Output
• AC-Coupled Input
• AC- or DC-Coupled Output
• Capable of PAL Frequency for CV
• Continuous Time Low-Pass Filters
• Integrated DC Restore Circuitry with Low Tilt
• 6 Vcc