Programmable USB Type-C Controller USB3.1 14-Pin WQFN T/R

The FUSB302T targets system designers looking to implement USB Type-C wall charger or Travel adaptor. In addition to the default SRC function, the device supports DRP/ SRC/ SNK with low amount of programmability.The FUSB302T enables the USB Type-C detection including attach/detach, and orientation. The FUSB302T integrates the physical layer of the USB BMC power delivery protocol to allow up to 100 W of power and role swap. The BMC PD block enables full support for alternative interfaces of the Type-C specification.

• Dual-role Functionality with Autonomous DRP Toggle
• Ability to Connect as Either a Host or a Device Based on What Has Been Attached
• Software Configurable Either as a Dedicated Host, Dedicated Device, or Dual Role
  • Dedicated Devices can Operate both on a Type-C Receptacle or a Type-C Plug with a Fixed CC and VCONN Channel
• Full Type-C 1.2 Support. Integrates the Following Functionality of the CC Pin:
  • Attach/Detach Detection as Host
  • Current Capability Indication as Host
  • Current Capability Detection as Device
  • Audio Adapter Accessory Mode
  • Debug Accessory Mode
  • Active Cable Detection
• Integrates CCx to VCONN Switch with Over-current Limiting for Powering USB3.1 Full Featured Cables
• USB Power Delivery (PD) 2.0 Support:
  • Automatic GoodCRC Packet Response
  • Automatic Retries of Sending a Packet if a GoodCRC is Not Received
  • Automatic Soft Reset Packet Sent with Retries if Needed
  • Automatic Hard Reset Ordered Set Sent
• Default CC Open for SRC Application
• Low Power Operation: ICC = 25 µA (Typical)
• AEC-Q100 Qualified and PPAP Capable
• Packaged in:
  • 14-lead WQFN (2.5 mm × 2.5 mm, 0.5 mm Pitch)